Yokogawa PC-Based MX100 - Manual (Page 74)

2-60 IM MX180-01E
2.11 Analog/PWM Output Settngs
Procedure
Analog Output Settngs
Transmission output
reference channel
Sets the output value upon
startup or error occurrence
Output range
selection
Minimum/Maximum value
of output span
Select the source action Select output
or no output
Selection of output
action upon errors
Click here
Select the output
action upon startup
1. Click Channel to show the Channel setup screen.
2. Click the AO Channel tab.
3. Select the Use check boxes for the AO channels you wish to output.
4. Specify a channel operation of Transmission output or User output. If user output
is specified, you can enter settings in the monitor screen.
Only one of all the AO and PWM channels can be selected for user output.
5. When transmission output is specified, enter the Reference channel.
The reference channel cannot be entered if the channel operation is user output.
6. Select a range from the Range list box.
7. Click the Min box or Max box under Span and enter the minimum or the maximum
value of the span.
8. Click the Power ON box under Output Action and select Hold previous value or
Preset value.
9. Click the Error box under Output Action and select Hold previous value or Preset
value.
10. If you select Preset value under Output Action, click Preset value, and enter the
voltage or current.