Yokogawa PC-Based MX100 - Manual (Page 114)

4-3
IM MX180-01E
Cal
brator
3
2
1
4
5
App
Index
Settng a Password for Startup
You can use the following procedure to set up the Calibrator so that it prompts the user
to enter a password upon startup.
1. From the File menu, click Set Password.
The password setting dialog box opens.
2. Click the New Password box, and enter a password.
There are no restrictions on the characters that can be used in the password. However, the
number of characters used must be no more than thirty.
3. Enter the same password in the Confirm New Password box, then click OK.
When the Calibrator is restarted, the password confirmation dialog box below appears.
If an incorrect password is entered and the OK button is clicked, the message, “Incorrect
Password” is displayed in a dialog box. Click OK to exit the Calibrator.
Note
To set up the Calibrator so that no password dialog box is displayed, open the password setting
dialog box, make sure the entry boxes are blank, and click OK There is no other way to cancel
the password, so make sure you do not forget the password once it is set.
Explanaton
Checkng the Connected MX100
When the connection is established, the Unit Information window shows the serial
number, MAC address, and input/output modules of the connected MX100. If you click
the Check button, the 7-segment LED on the main module of the connected MX100
shows the text “--CALL--” flowing from right to left.
4.1 Connectng the MX100