Yokogawa PC-Based MX100 - Manual (Page 27)

2-13
IM MX180-01E
Integrat
on Mon
tor
3
2
1
4
5
App
Index
Settng the A/D Integral Tme
When the measurement interval is one of the setting values in the table below, the A/D
integral time setting of the input module becomes active. The default setting is AUTO.
• AUTO
Automatically sets the A/D integral time to 50 Hz or 60 Hz according to the frequency
of the power supplied to the main module.
• 50 Hz
Sets the integral time to 20 ms.
• 60 Hz
Sets the integral time to 16.67 ms.
Input Module Type
Measurement
Interval Settng
4-CH, High-Speed Universal Input Module (MX110-UNV-H04) 50 ms
10-CH, Medium-Speed Universal Input Module (MX110-UNV-M10) 500 ms
30-CH, Medium-Speed DCV/TC/DI Input Module (MX110-VTD-L30) 1 s
6-CH, Medium-Speed Four-Wire RTD Resistance Input Module
(MX110-V4R-M06)
500 ms
4-CH, Medium-Speed Strain Input Module
(MX112-B12-M04, MX112-B35-M04, and MX112-NDI-M04)
200 ms
* For the A/D integral times when setting other measurement intervals, see chapter 4,
“Specification” in the MX100 Data Acquisition Unit User’s Manual” (IM MX100-01E).
Settng the Wrte Mode of the CF Card
If the connection between the software and the MX100 is dropped while the measured/
computed data is being recorded (see section 2.7), the measured data is saved (backed
up ) to the CF card on the main module. If the Cyclic Mode check box is selected and
measured data is saved in backup mode, the data continues to be saved by deleting
the oldest data file when there is no more free space on the CF card. If the check box is
cleared, data saving stops when there is no more free space on the CF card.
2.2 Confgurng the System, Settng the Wrte Mode of the CF Card, and Formattng the CF Card