Yokogawa PC-Based MX100 - Manual (Page 37)

2-23
IM MX180-01E
Integrat
on Mon
tor
3
2
1
4
5
App
Index
Note
• You can execute initial balancing and reset the initial balance value on multiple recording
channels at once by selecting the channels and clicking the collective execution button.
Drag and drop channels on which to perform initial balancing to select them
Selected channels are displayed with red characters against a gray background
Collective execution ON/OFF button
• To execute initial balancing on a strain input module, you must finalize MX100 channel
settings and send them. If invalid channel settings are entered, a dialog box will appear
prompting you to correct the settings.
Message
Intalzng, Copyng, and Pastng of Settngs on the Dsplay Setup Screen
The procedures are the same as those for Initializing, Copying, and Pasting of Settings
on the Display Setup Screen described in section 2.6.
Explanaton
Input Mode and Measurement Range
Measurement channel settings differ depending on the hardware style number of the
MX100. See the table below.
Connectable module types
or settng tems
MX100 Hardware
Style Number
*
Notes
S3 S2 S1
30ch module
MX110-VTD-L30
Yes No No –
GOST range Yes No No Can be set only for MX110-UNV-M10,
MX110-UNV-H04, MX110-V4R-M06, and
MX110-VTD-L30
Yes: Setting and operation allowed, No: Setting and operation not allowed
* The style number is printed on the MX100 main module name plate.
2.4 Settng the Measurement Condtons (Settng the Measurement Channels)