Yokogawa PC-Based MX100 - Manual (Page 16)

2-2 IM MX180-01E
3. Click the MX100 icon that appeared.
In the box containing the Edit Network setup button, the icon and the initial network
information of the selected MX100 appear.
Even if you click the Connect button in this condition (with the initial IP address), connection
cannot be made.
Click the MX100 icon
Clicking here causes the
7-segment LED of the
corresponding MX100 to
display --CALL--
Default network information
4. Click the Edit Network setup button.
The Machine Name, IP address, Subnet Mask, and Default Gateway items turn into text
boxes.
5. Refer to the explanations in this section and enter the required information in the
boxes.
The Apply and Cancel buttons appear.
6. Click Apply.
In the box containing the Edit Network setup button, the icon and the network information of
the MX100 disappear. At this moment, the 7-segment LED that has been configured turns
off for an instant.
Click the Edit Network setup button to
change the display to input boxes
Click
here
Enter the necessary information using
characters. Enter up to 64 characters
for the machine name
When you click the Apply button
the icon and network information
disappear.
• Invalid IP address setting • Invalid Subnet mask
setting
• Invalid default
gateway setting
If the network setup does not work, the following screen appears.
Check whether the IP address
setting is appropriate and whether
the combination of the IP address
and subnet mask is appropriate.
Check whether the
subnet mask setting
is appropriate.
Check whether the
default gateway
setting is appropriate.
• Failed to change
settings
Check if the MX100 is
connected by another
program or if the power
to the MX100 is OFF.
• Failed to change
settings
Repeat steps 2 through 6
2.1 Connectng and Dsconnectng the MX100