Yokogawa PC-Based MX100 - Manual (Page 94)

4-6 IM MX100-01E
Display
LED: Ethernet communication status (LINK, ACT)
Two-digit 7-segment LED: Status of the MX100 (unit number, operation status, and error
indication)
Communications
Interface: Ethernet (10BASE-T/100BASE-TX)
Connector type: RJ-45
Protocol: TCP, IP, UDP, ARP, and ICMP
Transmission function: Transmits measured values and settings
Reception function:
Receives settings
TCP connection timeout: If there is no packet exchange for three minutes or more (not
configurable) when using TCP, a connection timeout occurs.
This mainly occurs when using the MX100/DARWIN API (sold
separately).
Other Functions
Time function: Normally operates using the PC clock
Backup function available (records the times of the data using
time stamps of the main module when communication is
disconnected)
Internal clock accuracy: ±100 ppm
Dip switches:
Used to initialize settings, etc. (number of switches: 8)
Access stop switch (CF card control switch):
Closes the file to which data is being written on the CF card
Saves the log file
Memory backup Settings and the clock are maintained by the internal lithium
battery, which has a lifetime of approximately 10 years (under
standard operating conditions)
General Specifications
Power consumption: Approximately 8 W
Insulation resistance: 20 MΩ or more at 500 VDC between the power supply terminal
and earth terminal
Withstand voltage: 1500 VAC (50/60 Hz) for one minute between the power supply
terminal and earth terminal
External dimensions: Approximately 92 (W) × 131 (H) × 137 (D) mm
Weight:
Approximately 0.85 kg
External Dimensions
92 136.7
13
1
Unit: mm
If not specified, the tolerance is ±3%. However, in cases of less than 10 mm, the tolerance is ±0.3
mm.
4.2 Main Module (MX100-E) Specifications