Yokogawa PC-Based MX100 - Manual (Page 52)

2-7
IM MX100-01E
Installation and W
iring
3
2
1
4
5
Index
Attaching and Removing the Terminal Block
The terminals of the input/output modules in the figure below can be removed. The
terminals of the 30-CH, Medium-Speed DCV/TC/DI Input Module (MX110-VTD-L30)
cannot be removed.
The terminal cover can be removed by pressing backward with the cover lifted up.
4-CH, High-Speed Universal
Input Module
The terminal block can
be attached and
detached.
4-CH, Medium-Speed Strain
Input Module (-B12, -B35)
Pull-out
handle
The terminal plate can be
attached and detached.
Attachment screw
(Loosen before removing the terminal plate.)
10-CH, Medium-Speed Universal Input Module/
6-CH, Medium-Speed Four-wire RTD
ResistanceInput Module/
10-CH, High-Speed Digital Input Module
8-CH, Medium-Speed Analog Output Module/
8-CH, Medium-Speed PWM Output Module/
10-CH, Medium-Speed DigitalOutput Module
The terminal plate can be
attached and detached.
Attachment screw
(Loosen before removing the terminal
plate.)
Attachment screw
(Loosen before removing the terminal block.)
Pull-out
handle
The terminal block can be
attached and detached.
2.4 Connecting the Signal Wires