Yokogawa PC-Based MX100 - Manual (Page 53)

2-8 IM MX100-01E
Attaching Plates with Screw Terminals and Plates with Clamped Terminals for
Current
You can attach a plate with screw terminals (sold separately, M3 screws) to the 10-CH,
Medium-Speed Universal Input Module and the 10-CH, High-Speed Digital Input Module.
You can also attach a plate with clamped terminals for current (sold separately) to the
10-CH, Medium-Speed Universal Input Module.
The plate is attached and removed in the same manner as terminal blocks. Note that the
terminal arrangement of the plate with screw terminals differs from that of the plate with
clamped terminals. The terminal arrangement is displayed on the back of the terminal
cover in the same package. Replace it along with the plate.
For handling of the plate with screw terminals, see the MX100/MW100 Handling of the
Plate with Screw Terminals (IM MX100-77E), and for the plate with clamped terminals for
current, see the MX100/MW100 Setting Up the Plate with Clamp Terminals for Current (IM
MX100-78E).
100mA
10
1
2
5
4
8
7
11
10
14
13
1
2
5
4
8
7
11
10
14
13
Attachment
screw
Plate with screw terminals
(model 772080)
Attachment
screw
Plate with clamp terminals for current
(model 772081 (10 Ω)/772082 (100 Ω)/772083 (250 Ω))
Screw Terminal Block
The 10-CH, Medium-Speed Universal Input modules and 10-CH, High-Speed Digital
Input modules allow you to remove the terminal plate and connect a 10-channel screw
terminal block (M4 screws, sold separately) that can be attached to a DIN rail (see the
figure below).
CH 1
CH 2
CH 3
CH 4
CH 5
CH 6
CH 7
CH 8
CH 9
CH 10
b B A
10-CH, Medium-Speed Universal Input Module/
10-CH, High-Speed Digital Input Module
DIN rail
Latch lever
(Pull down to detach.)
Terminal cover
b +/A
–/B
10-CH screw terminal block (772061)
10-CH screw terminal
block (772061)
Connection cable
between the input module
and screw terminal block
(772062-0XXX*)
* Length: 050 or 100 cm.
Attachment to a DIN Rail
Connector cover
Attachment screw
for connector cover
Loosen the attachment screw for the connector
cover and open the connector cover.
Attachment screw
Attachment screw
2.4 Connecting the Signal Wires