Yokogawa PC-Based MX100 - Manual (Page 15)

1-6 IM MX100-01E
PC Software
One MX100 can be connected to a PC, and the MX100 Standard Software (that can
acquire measured data) is included. The MX100 Standard Software consists of the
three software programs below. For details about the software functions and operating
procedures, see the MX100 Standard Software User’s Manual (IM MX180-01E). When
configuring a system using the MX100, the software release number and hardware style
number matching conditions must be met (see “Notes” on page i).
Integration Monitor
Enables you to connect or disconnect communications, configure acquisition conditions
and display conditions of the measurement channels, set up computations channels,
monitor measured and computed data, save measured and computed data, and carry
out other operations.
Viewer
Enables you to display measured and computed data that has been saved, read
values and perform statistical computation over an area using cursors, and convert the
measured and computed data into various file formats such as Excel.
Calibrator
This program is used to calibrate the MX100 universal input modules, DCV/TC/DI input
modules, 4-wire RTD resistance input module, strain input modules, and analog output
module.
1.1 Overview of the MX100