Yokogawa PC-Based MX100 - Manual (Page 68)

2-23
IM MX100-01E
Installation and W
iring
3
2
1
4
5
Index
Checking the Communication Status
You can check the status on the two LEDs at the upper-right and lower-right of the
Ethernet port.
ETHERNET
10BASE - T
100BASE - TX
LINK LED
Illuminates in orange when the link between
the MX100 and the connected device is
established and communication is mutually possible.
ACT LED
Blinks green when transmitting/receiving packets.
Initializing the Settings
The dip switch on the main module is used to initialize the settings including the IP
address assigned to the MX100.
1. Turn OFF the power to the MX100.
2. Turn dip switch 5 of the main module OFF.
3. Turn ON the power to the MX100.
The 7-segment LED indicates the self-test operation at power up (see section 1.2, “Main
Module Functions”), and then displays bF.
4. Check the status of step 3, then turn the power OFF.
5. Turn dip switch 5 back ON.
Check that the settings have been initialized (using the MX100 Standard Software, for
example).
Power switch
7-segment LED
Dipswitches
DATA ACQUISITION UNIT
ETHERNET
POWER
10BASE - T
100BASE - TX
100 - 240V AC
Do not operate without reading safety precaution in users manual.
70VA MAX
50/60Hz
SW ON
1 2 3 4 5 6 7 8
• Normal setting
• Turn switch 5 OFF
Open the cover during
operation.
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON
2.6 Connecting the Ethernet Cable