Yokogawa PC-Based MX100 - Manual (Page 20)

1-11
IM MX100-01E
Explanation of Functions
3
2
1
4
5
Index
Contents Displayed on the 7-Segment LED
The two-digit 7-segment LED displays the unit number, operating status, operation
complete, and operation error of the MX100.
Unit Number Display
When connecting to the MX100 Standard Software, the unit number is fixed to 00 and
displayed as “
.” When connecting to MXLOGGER (sold separately), the unit number
is displayed as “ ” to “ .”
Display of the Self-Test Operation at Power On
When the power is turned ON the dip switch indicator lights (normally displays “ ”,
or “ ” when the /DS option functions enabled), the operation ready indicator lights
(the display, and others), then the self-test is carried out. While the self-test is in
progress, the following symbols are alternately displayed.
Operation Mode Hold Function Display (Only When the /DS Option
Function is Installed)
Following the self-check, the /DS option function execution confirmation (“ ” is
displayed.
Operation Mode Display
The MX100 has three operation modes: idle mode, measurement mode, and backup
mode (measured data saved to a CF card due to the disconnection of communications).
The modes are displayed as shown below. In the figure below,
indicates the unit
number. If the unit number is not 00, the specified unit number is displayed.
• Idle mode • Measurement mode • Backup mode
Two zeroes Two zeroes and a dot Two zeroes and two dots
Display When Operation Is Complete
The figure below shows the display that appears when an operation such as IP address
configuration and measurement condition change is completed. In the figure below, the
unit number is “
.” If the unit number is not 00, the specified unit number is displayed.
Turns off
for 1 second
Display during Processing
The displays shown below repeats when the CF card is accessed, when the CF card is
being formatted, or when calibration is taking place.
Unit Confirmation Display
The figure below shows the display that appears when you confirm the MX100 that is
connected using the MX100 Standard Software or MXLOGGER (sold separately). The
word –CALL– flows through the display from left to right.
Operation Error Display
For details on the display and meaning of errors, see section 3.1, “Error Display on the
7-Segment LED and Corrective Actions.”
1.2 Main Module Functions