Yokogawa Button Operated MV2000 - Manual (Page 91)

3-11
IM MV1000-01E
Measurement Channels and
Alarms
1
2
3
4
5
6
7
8
9
10
11
12
13
App
Index
3.7 Settng Alarms on Channels
Configure alarms after you have set the range. A channel’s alarm settings are reset when
the following occur:
• When the input type (Volt, TC, etc.) is changed.
• When the input range is changed.
• When the upper or lower limit of the span or scale is changed on channels that are set
to linear scaling, square root computation, or 1-5V input (this includes changes in the
decimal place).
For an explanation of this function, see section 1.3.
Dsplay
• Alarms for Each Channel
Press MENU and then select > Menu tab > Meas channel > Range, Alarm.
• Alarm Delay
MV1000
Press MENU and then select > Menu tab > Meas channel > Tag, Memory, Delay.
MV2000
Press MENU and then select > Menu tab > Meas channel > Tag, Memory sample,
Alarm delay.