Yokogawa Button Operated MV2000 - Manual (Page 83)

3-3
IM MV1000-01E
Measurement Channels and
Alarms
1
2
3
4
5
6
7
8
9
10
11
12
13
App
Index
3.3 Settng the Input Range
This section explains how to set the input range for each channel.
Dsplay
Press MENU and then select > Menu tab > Meas channel > Range, Alarm.
Settngs
• Frst-CH, Last-CH
Select the target channels.
• Range > Mode
Settng Descrpton
Skip Not measured.
Volt, TC, RTD, DI, 1-5V Input type. Represents DC voltage, thermocouple, RTD,
ON/OFF input, and 1-5V inputs, respectively.
Delta, Scale, Sqrt Difference computation, linear scaling, and square root
computation.
Select the checked settings for the modes listed below.
Settng Mode
Volt TC RTD DI Delta Scale Sqrt 1-5V Skp
Type  
Range        
Span Lower        
Span Upper        
Scale Lower   
Scale Upper   
Unt   
Ref. CH 
Low-cut  
Low-cut value 