Yokogawa Button Operated MV2000 - Manual (Page 45)

1-36
IM MV1000-01E
1.7 Event Acton Functon
The event action function performs a specified action when a specified event occurs. The
remote control function (/R1 option) is configured using the event action function.
For configuration instructions, see section 7.1.
Event
• Lst of Events
You can choose from the following events:
Event Level/edge* Descrpton
Remote Level/edge Remote control input ON or OFF.
Relay Level/edge Alarm output relay activation or deactivation.
Switch Level/edge The internal switch value (0 or 1).
Timer Edge Timer timeout
MatchTimeTimer Edge When a specified time is reached.
Alarm Level/edge An alarm is occurring/no alarms are occurring
UserKey Edge When the USER key is pressed.
* For a description of level and edge, see “Miscellaneous” in this section.
• Tmers
There are four kinds of timers. They are also used with the TLOG computation
function (/M1 and /PM1 options).
Types of Tmers
Time
Relative timer Absolute timer
Timer set
Timer reset
B: Interval Timeout
Time
Timer set Ref. time
A: Interval
A B B A A A
• Absolute Tme Mode
The timer expires at the times determined by the reference time and the interval.
The reference time can be set to the hour (00 to 23).
Example: Reference time: 00:00
Interval:
10 min
The timer expires at 00:00, 00:10, 00:20, ... 23:40, and 23:50. For
example, if the timer is set at 09:36, the timer expires at 09:40, 09:50,
10:00, and so on.
• Relatve Tme Mode
Timing begins when the timer is set, and the timer expires and then begins timing
again at each interval. With this mode, the timer will stop when there is a power
failure and will not resume afterwards.
Example: Interval: 00:15
The timer expires every 15 minutes.