Yokogawa Integral Oxygen Analyzer ZR202 - Manual (Page 149)

<10. Other Functions>
10-11
IM 11M12A01-02E
10.3 Parameter Initialization
Parameter settings can be initialized to the factory default settings. Initialization can be done
for all parameters or for individual parameters. The parameters that can be initialized and their
defaults are listed in Table 10.5.
(1) On the Basic panel display, touch the [Setup] key to display the Execution/Setup display.
(2) Select “Commissioning”, next “Others” then “Defaults”. A display like Figure 10.11. appears.
(3) Select the desired item to be initialized then a display like Figure 10.12 appears.
Select “Defaults start” then initialization starts.
Display

Calibration
 Blow back
 mA-outputs
 Alarms
 Contacts
 Others
 All data
Enter
Defaults
F10.11E.ai
Enter
Defaults start

Cancel
Defaults
Display
Figure 10.11 Defaults Display Figure 10.12 Initialization Start Display
CAUTION
• Do not turn off the power during initialization. Otherwise, initialization will not be performed
properly.
8th Edition : Jan.13,2012-00