Teledyne LeCroy SAS Suite User Manual - Manual (Page 259)

SASSuite User Manual Version 6.25
LeCroy Corporation
249
Scrambling Mode Settings
ScramblingMode >>>>> Raw Data Scrambling Mode - Only those raw
dwords will be scrambled that contain only
data bytes (no 10bit symbols or 'K' bytes.
Scrambling is reset by changing
ScramblingMode or by any valid SAS or SATA
frame. Possible Values:
SCRAMBLING_MODE_NONE
SCRAMBLING_MODE_SAS
SCRAMBLING_MODE_SATA Default Value:
SCRAMBLING_MODE_NONE
Wait Timeout Settings
WaitTimeout 1000 Sets global WaitTimeout value in
microseconds
AUTO_WAIT_SAS_AFTER Settings
AUTO_WAIT_SAS_
AFTER_
CLOSE_FOR_CLOSE
FALSE When set, the generator will insert WAIT_FOR
CLOSE command immediately after each
CLOSE primitive.
AUTO_WAIT_SAS_
AFTER_EOF_FOR_ACK
FALSE When set, the generator will insert WAIT_FOR
ACK command immediately after each EOF
primitive.
AUTO_WAIT_SAS_
AFTER_EOF_FOR_
ACK_OR_NAK
FALSE When set, the generator will insert WAIT_FOR
ACK or NAK command immediately after each
EOF primitive.
AUTO_WAIT_SAS_
AFTER_OPEN_FOR_
OPEN_ACCEPT
FALSE When set, the generator will insert WAIT_FOR
OPEN_ACCEPT command immediately after
each Open Address Frame.
AUTO_WAIT_SAS_
AFTER_OPEN_FOR_
OPEN_REJECT
FALSE When set, the generator will insert WAIT_FOR
OPEN_REJECT command immediately after
each Open Address Frame.
AUTO_WAIT_SAS_
AFTER_IDENTIFY_
FOR_IDENTIFY_
FRAME
FALSE When set, the generator will insert WAIT_FOR
Identify Frame command immediately after
each Identify Address Frame.
AUTO_WAIT_SAS_
AFTER_SMP_REQ_
FOR_RESP
FALSE When set, the generator will insert WAIT_FOR
SMP Response Frame command immediately
after each SMP Request Frame.
Setting
Default
Value Description