Teledyne LeCroy Kibra DDR - Manual (Page 166)

Teledyne LeCroy DDR3 and DDR4 JEDEC Timing Violations Summary
164 Kibra DDR Protocol Analyzer User Manual
5.1.22 V22 - tddWTW WRITE to WRITE delay (different rank, same DIMM)
Defined as the interval between a WRITE command and the next Write command to a
different rank in same DIMM. Timing between commands to a different rank should be
vendor specified.
5.1.23 V23 - tddWTW WRITE to WRITE delay (different DIMM)
Defined as the interval between a WRITE command and the next Write command to
different DIMM. Timing between commands to a different rank or DIMM should be
vendor specified.
5.1.24 V24 - tXS SELF REFRESH EXIT to a Valid Command (without DLL)
Defined as the interval between Self Refresh Exit command and the next Valid command
that doesn’t need DLL. Exiting Self‐Refresh (SRX) is transmitted by a combination of CKE
high plus NOP / Deselect command. A delay of at least tXS (5nCK, tRFC(min)+10ns) must
be satisfied before a valid command (not requiring a locked DLL) can be issued. This is to
allow completion of any internal refresh operations in progress.
5.1.25 V25 - tXSDLL SELF REFRESH EXIT to a Valid Command (with DLL)
Defined as the interval between Self Refresh Exit command and the next Valid command
that needs DLL. Exiting Self‐Refresh (SRX) requires combination of CKE high plus NOP /
Deselect command asserted for at least 2 CKs. Before a command that requires a locked
DLL can be applied, a delay of at least tXSDLL (512 CKs) and applicable ZQCAL function
requirements (TBD) must be satisfied.
5.1.26 V26 - tCKESR SELF REFRESH ENTRANCE to SELF REFRESH EXIT
Defined as the minimum interval between Self Refresh entrance and Self Refresh Exit. At
Self Refresh Entry, CKE must be low plus the NOP / Deselect command asserted for at
least 2CKs followed by Self Refresh exit where CKE must be high plus the NOP / Deselect
command asserted for at least CKE + 1.
5.1.27 V27 - tACTPDEN ACTIVE to POWER DOWN ENTRY
Defined as the interval between Active command and initiating Power down entry. Active
can be issued one clock prior to initiating PDE for all speed bins.
5.1.28 V28 - REFPDEN REFRESH to POWER DOWN ENTRY
Defined as the interval between Refresh command and initiating Power down entry.
Refresh can be issued one clock prior to initiating PDE for all speed bins.