Teledyne LeCroy Kibra DDR - Manual (Page 109)

Kibra DDR Protocol Analyzer User Manual 107
Waveform View Teledyne LeCroy
3.2.6 Zoom In and Zoom Out
Click on the Zoom In button and the Zoom Out button to toggle between
zooming in and out. The buttons are shown in the screen capture below.
Note: The Zoom In/Out buttons turn grey when the display is at maximum/minimum zoom.
Figure 3.8: Zoom In and Zoom Out Buttons
3.2.7 Overlay Signals Mode
Click on the Enable/Disable Overlay Signals Mode button to toggle between
enabling and disabling the overlay signals mode. Overlay Signals mode allows you to take
a single signal and superimpose it on top of another signal, the top signal stays
translucent.
Figure 3.9: Enabling/Disabling Overlay Signals Mode
To overlay a signal, perform the following steps.
1. Click on the Enable/Disable Overlay Signals Mode button to activate it as shown in
the screen capture above.
2. Click on the signal to be overlaid, grab and move it as shown in the following screen
capture.
Zoom In Zoom Out
Enable/Disable Overlay Signals Mode button.
When activated the button turns blue.