Teledyne LeCroy Kibra DDR - Manual (Page 115)

Kibra DDR Protocol Analyzer User Manual 113
Waveform View Teledyne LeCroy
Figure 3.19: Timing Violation and Protocol Violation Tooltip
Hover over the violation to display the Timing Violation dialog (see figure above) and click
the Add Cursor link to add a cursor which demarcates the start time of the violation to
the actual occurrence. Use the buttons to move to either side of the cursor (violation) by
clicking the buttons on the top right corner (see figure below). The buttons from left to
right are:
 Zoom to fit: This will change Waveform view, zoom and position to show
this cursor boundaries (X and Y positions) in the current view,
so user can see all parts of this cursor together.
 Go to X: Positions the X cursor in the middle of the view (without chang‐
ing zoom).
 Go to Y: Positions the Y cursor in the middle of the view (without chang‐
ing zoom).
 Close/Remove: Removes this cursor from view.
Figure 3.20: Additional Tool-tip Functionality