Datamax-O'Neil I-Class Operator’s Manual - Manual (Page 89)

I-Class 79
5.6.3 Cleaning Interior and Exterior Surfaces
Interior Surfaces – Turn OFF and unplug the printer. Remove all media. Then, using a soft
bristle brush or compressed air, remove all dust particle buildup inside the printer.
Exterior Surfaces – Turn OFF and unplug the printer. Remove all media. Then, using a
soft cloth or sponge dampened with general-purpose cleanser (never abrasive cleansers or
solvents) wipe the exterior surfaces until clean.
5.7 Application Updates
As available, application program (firmware) updates can be found on our web site at
http://www.datamax-oneil.com and then installed in the printer.
The update can be performed in Ready Mode or in Download Mode. Before updating, identify
the current program version by printing a Configuration Label (see Section 4.2.2). Compare
that version string to those available from our web site then download the desired file onto
your computer’s hard drive. Proceed according to the currently installed version:
•
If 2.091 or greater, see Section 5.7.1 or 5.7.2.
• If 2.08 or less, see Section 5.7.2.
 Notes: If updating to version 11.021 or greater, the Boot Loader must be updated
before proceeding; see Section 5.8.
Also, those desiring an alternate menu language must also download the
EFIGS menu language file. Go to the EFIGS directory and copy 832296.01C
(or most current version) to lpt1: /b (where the DOS Copy command
requires the /b parameter because this file contains binary code).
WARNING
If an error occurs during downloading, the update will be terminated. If the
process did not reach ERASING FLASH or UPDATING SOFTWARE, the
previous program will remain intact; otherwise, a successful download must
be completed to make the printer operable.