Datamax-O'Neil I-Class Operator’s Manual - Manual (Page 112)

102 I-Class
Dimensional Requirements are listed in the following table:
E
J
I
C
K
A
B
D
H
F
G
Side View Top View
Media Dimensional Requirements
Designator Description Minimum [1] Maximum [1]
A Label width 1.00 4.65
B Liner width 1.00 4.65
C Gap (or notch) between labels [3] .10 –
D Label length [3] .25 –
E Media thickness .0025 .010
F Notch opening width .20 .500
G Media edge to sensor aperture distance .20 2.25
H Reflective (black) mark width [2] .50 4.65
I Distance between reflective marks [3] .50 –
J Reflective mark length [3] .10 –
K Label repeat distance [3] .35 –
[1] Units of measure are given in inches and referenced by the direction of label feed.
[2] The reflective (black) mark must be carbon based, placed on the backside of the stock, and the
reflectance shall be less than 10% at wavelengths of 950 and 640 nm.
[3] The maximum allowable length of the combined label and gap (or mark) measurement cannot
exceed 99.99 inches.