Datamax-O'Neil I-Class Operator’s Manual User Manual

Page 64

I-Class

Diagnostics (continued)

Menu Item

Details

LOOPBACK

Not Supported

PRINT SIGNAL INFO

Prints signal names, pin assignments, settings, and

current states for reference.

GPIO SIGNAL INFO

WED 11:04AM 24MAR2003
CARD ID#1

OUTPUT SIGNALS

END OF PRINT
PIN# 6
LOW PULSE
CURRENT LEVEL 1

RIBBON LOW
PIN# 5
ACTIVE LOW
CURRENT LEVEL 1

SERVICE REQUIRED
PIN# 4
ACTIVE LOW
CURRENT LEVEL 0

MEDIA OUT
PIN# 3
ACTIVE LOW
CURRENT LEVEL 1

RIBBON OUT
PIN# 2
ACTIVE LOW
CURRENT LEVEL 1

INPUT SIGNALS

START OF PRINT
PIN# 8
ACTIVE HIGH
CURRENT LEVEL 0

BACKUP LABEL
PIN# 7
DISABLED
CURRENT LEVEL 0

TEST SCANNER

Tests the Linear Scanner, where:

ALIGNMENT TEST

Reads a bar code then displays the decoded data, the

code type and scan count, repeating.

SCAN TEST

Reads a bar code then displays the decoded data, the

code type and scan count, non-repeating.

TEST RFID

Tests RFID, where:

TAG DATA

Reads the data encoded on the RFID chip.

DEVICE VERSION

Displays the type and version of the encoding device.

TAG ID – HF ONLY

Reads and displays the High Frequency Tag ID number.

PRINT TEST RATE (min)

Allows a label-to-label delay (0 - 120 minutes) when

printing test label batches, where:

000 (0 - 120)

Is the selected delay interval, in minutes.