Datamax-O'Neil I-Class Operator’s Manual - Manual (Page 36)

26 I-Class
4.2.3 Print Control
The Print Control menu contains print quality, throughput, formatting, and custom setup
functions:
Menu Item Details
HEAT
Controls the burn-time of the printhead (selectable as
“Heat” in most labeling programs), where:
10 (0 - 30) Is the number based on duration, corresponding to
print darkness.
PRINT SPEED
Controls the rate of label movement during printing,
where:
XXin/sec (X - XX) Is the speed setting; see Appendix A for the model
dependant default and range.
 Note: Detailed image printing may require slower
speeds; alternately, faster printing may
require an increased HEAT setting for
sufficient energy transfer.
FEED SPEED
Controls the rate of label movement between printing
areas, where:
XXin/sec (X - XX)
Is the speed setting; see Appendix A for the model
dependant default and range.
REVERSE SPEED
Controls the rate of label movement during backup
positioning, where:
XXin/sec (X - XX)
Is the speed setting; see Appendix A for the default
and range.
SLEW SPEED
Controls the rate of label movement between printing
areas when using the GPIO option, where:
XXin/sec (X - XX)
Is the speed setting; see Appendix A for the default
and range.
ROW OFFSET
Shifts the vertical SOP position on the label, where:
00.00in (0 - 99.99)
Is the offset distance; see Section 7.2.2 for label
details.
COLUMN OFFSET
Shifts the horizontal, left-justified SOP position to the
right without shifting the Label Width termination point
to the right, where:
00.00 in (0 - 99.99)
Is the offset distance; see Section 7.2.2 for label
details.