Datamax-O'Neil I-Class Operator’s Manual - Manual (Page 109)

I-Class 99
Printing (continued)
Maximum Print Width: 4.10” (104.0 mm): I-4206, I-4208, I-4212
4.16” (105.7 mm): I-4308
4.10” (104.0 mm): I-4406
4.16” (105.7 mm): I-4604
Print Length Range:
with cutter:
with peel & present:
.25”- 99” (6.4 - 2514.6 mm): I-4206, I-4208, I-4212, I-4308
.25”- 84” (6.4 - 2133.6 mm): I-4406
.25”- 55” (6.4 - 1397 mm): I-4604
1.25”- 99” (31.8 - 2514.6 mm): I-4206,I-4208, I-4212, I-4308
1.25” - 84” (31.8 - 2133.6 mm): I-4406
1.25” - 55” (31.8 - 1397 mm): I-4604
1.50” - 99” (38 – 2514.6 mm): I-4206, I-4208, I-4212, I-4308
1.50” - 84” (38 – 2133.6 mm): I-4406
1.50” - 55” (38 – 1397 mm): I-4604
Print Justification: Left
Flash Memory: 1 MB: I-4206, I-4208
2 MB: I-4212, I-4308, I-4406, I-4604
SDRAM Memory: 8 MB: I-4206, I-4208
16 MB: I-4212, I-4308, I-4406, I-4604
Media Types: Roll-Fed, Die-Cut, Continuous, and Fan-Fold. Flat on the
printable side with no more than .0007” (.018 mm) protrusions
on the opposite side.
Media Roll Capacity: 8” (203 mm) outer diameter, wound out labels only
Media Core: 1.5” or 3.0” (38 mm or 76.2 mm) inner diameter
Ribbon Core: 1.010” .006” (25.6 mm .2 mm) inner diameter. Core not to
protrude beyond ribbon edge.
Ribbon Width Range: 1.0” – 4.5” (25.4 mm – 114.3 mm), where Coated Side In and
Coated Side Out ribbon is NOT interchangeable and is specified
by the Thermal Transfer option type; also, width should
slightly exceed that of the media and backing, if any, to
protect the printhead.
Ribbon Length: 1968 feet (600 meters) maximum