Datamax-O'Neil I-Class Operator’s Manual - Manual (Page 105)

I-Class 95
Fault Messages (continued)
Fault Messages
Displayed Message Description Action(s)
TOP OF FORM FAULT
The printer could not find
the TOF within the
maximum label length
setting, or TOF occurred in
an unexpected place.
 Note: When using
reflective media, this fault
is given for an Out of Stock
condition.
If media is moving:
1) Press the FEED Key. It may be
necessary to re-calibrate the
printer; see Section 5.2.
2) The Media Sensor may be out
of position. Readjust it; see
Section 3.3.
3) The media may not be
properly loaded. Reload
media, ensuring that the
Media Guide is properly
positioned; see Section 3.2.
4) The Leveling Cam may be
improperly adjusted; see
Section 5.4.1.
5) The label may be longer than
the value entered. Check the
Media Settings / Maximum
Label Length; see Section
4.2.2.
6) The Media Sensor may be
obstructed. Check and
carefully remove any
obstruction (labels, paper
dust, adhesive, etc).
If media is not moving:
The printhead assembly may not
be locked.
VERIFIER FAULT
The Verifier could not pass
a bar code.
 Note: This is normal
when a bar code is
unreadable.
Simultaneously press the ENTER
and F1 Keys on the Verifier to
clear the fault. If the fault
persists, consult the option’s
instructions.