Datamax-O'Neil I-Class Operator’s Manual - Manual (Page 57)

I-Class 47
Communications (continued)
Menu Item Details
WLAN ADHOC?
CANCEL KEY = YES Restores the WiFi defaults and initiates infrastructure
mode with an SSID of “Any.” All existing access point
associations will be deleted then established with the
closest available. (Useful when moving the printer to a
geographically distant location.)
 Note: Press the ESC Key to exit the menu item
without changing the current settings.
SET FACTORY DEFAULTS Returns the factory-programmed values, where:
SET DEFAULTS?
CANCEL KEY = YES Restores the default settings.
 Note: Press the ESC Key to exit the menu item
without changing the current settings.
WLAN
Controls the communications settings for the optional
DMXrfNetII Card, where:
MODE
Selects between Wired or WiFi operation, where:
ENABLED
Enables the WiFi interface.
DISABLED
Enables the Wired interface.
BSS ADDRESS
Specifies the WiFi bridge module’s static IP address.
 Note: If DHCP is ENABLED, this parameter will be
ignored.
 192.168.010.001 Is the address in standard octet format.
SIGNAL READINGS
Displays the signal and noise ratios for the WLAN.
IP ADDRESS Specifies the static IP Address; where:
192.168.010.026
Is the address in standard octet format.
SUBNET MASK Specifies the static Subnet Mask Address, where:
255.255.255.000
Is the address in standard octet format.
GATEWAY Specifies the network Gateway Address, where:
192.168.010.026
Is the address in standard octet format.