Datamax-O'Neil I-Class Operator’s Manual - Manual (Page 60)

50 I-Class
Communications (continued)
Menu Item Details
SET FACTORY DEFAULTS
Returns the NIC to factory-programmed values, where:
SET FACTORY DEFAULTS?
CANCEL KEY = YES Restores the default settings.
 Note: Press the ESC Key to exit the menu item
without changing the current settings.
HOST SETTINGS
Sets host communication parameters; where:
HOST TIMEOUT
Sets the period that an interface port can be idle before
timeout occurs, where:
10 SEC (1 - 60) Is the time (in seconds) when downloads timeout, and
that must elapse before alternate port or alternate
parser processing can occur.
CONTROL CODES
Allows changes to the software command interpretation
controls, where:
STANDARD CODES
Sets the following command interpretation codes: Hex
01 = SOH command; Hex 02 = STX command; count-
by = ^; Hex 1B = ESC; Hex 0x0D = Carriage Return
ALTERNATE CODES
Sets the following command interpretation codes: Hex
5E = SOH command; Hex 7E = STX command; count-
by = @; Hex 1B = ESC; Hex 0x0D = Carriage Return
ALTERNATE CODES 2
Sets the following command interpretation codes: Hex
5E = SOH command; Hex 7E = STX command; count-
by = @; Hex 1B = ESC; Hex 0x7C = Carriage Return
CUSTOM CODES
Sets the command interpretation codes as needed,
where:
SOH STX CR CNTBY
5E 7E 0D 40 Are the codes according to your definitions.
FEEDBACK CHARACTERS
Allows the return of printer codes, where:
DISABLED
Does not send feedback characters.
ENABLED
Sends the host a Hex 1E (RS) after each label and a
Hex 1F (US) after each label batch successfully prints.
ESC SEQUENCES
Allows data containing invalid ESC control code
sequences to be processed, where:
ENABLED
Processes commands normally.
DISABLED
Ignores ESC sequences during processing (since some
systems send a “banner” to the printer).
 Note: Bitmapped font downloads are disabled.