Datamax-O'Neil I-Class Operator’s Manual - Manual (Page 39)

I-Class 29
Printer Options (continued)
Menu Item Details
CUT BEHIND
Allows a number of small labels to queue before a cut is
performed, increasing throughput, where:
 Note: This mode can be used without a cutter to
allow the presentation of an extra label, with
retraction occurring upon the next job or feed
operation.
0 (0 – 2)
Is the queue number.
 Note: After a fault or unknown label position, the
leading edge will be cut to ensure no extra
material exists at the beginning of the first
label; otherwise, cutting will occur only as
specified.
SCANNER
Controls the Linear Scanner option, where:
MODE
Sets the detection method and response of the printer,
where:
AUTO
Checks for the presence of the scanner: If found, the
scanner is enabled; otherwise, it will be ignored.
ENABLED
Enables the scanner. If not detected, a fault will be
generated.
DISABLED
Disables the scanner.
BARCODES
Specifies the bar code type(s) for scanning, where:
 Note: Enabling only the bar code types that will be
checked can help maximize throughput.
CODE 39
IATA
CODABAR
INTERLEAVED 2 OF 5
INDUSTRIAL 2 OF 5
CODE 93
CODE 128
MSI/PLESSEY
EAN(13/8)
EAN(13/8)+2
EAN(13/8)+5
UPC(A/E)
UPC(A/E)+2
UPC(A/E)+5
Is / are the bar code type(s) to be checked; see the
Class Series 2 Programmer’s Manual for symbology
details.