ABUS FU8007 Secvest 2WAY Base Kit Installation User Manual
Page 84
84
Battery fault OK
-
-
-
YR
Battery missing
-
-
-
YM
Battery missing OK
-
-
-
YR
ISDN/GSM fault
-
-
-
LT
ISDN/GSM fault OK
-
-
-
LR
PSTN fault
-
-
-
LT
PSTN fault OK
-
-
-
LR
Jamming
-
-
XQ
XQ
Supervision fault
-
-
BZ
BZ
Supervision fault OK
-
-
-
-
RF battery fault
-
-
XT
XT
Set
-
CL
CL
CL
Internal active
-
CL
CL
CL
Unset
-
OP
OP
OP
Key switch set
CS
CS
CS
CS
Key switch unset
OS
OS
OS
OS
Download successful
-
-
RS
RS
Tamper user code
-
JA
JA
JA
Omit zone
BB
BB
BB
BB
Man. trigger test report
RX
RX
RX
RX
Period. test report
RP
RP
RP
RP
Time / day changed
-
-
-
JT
Prog. mode start
-
LB
LB
LB
Prog. mode end
-
LS
LS
LS
User code changed
-
-
-
JV
User code deleted
-
-
JX
Default password setting
loaded
-
-
RH
RH
End time limit
EA
EA
EA
EA
User 00
= Installer
User 01
= Admin User
User 02-50
= User
User 51
= Quick set
User 52
= Key Sw Latched/ Key Sw Moment
User 53
= Downoader
20.1.10 SIA Report Restorals
Select whether the restoration of a function (closing of an alarm zone, error clearance)
should be transmitted to the command centre. If this function is disabled, only faults or
alarms are transmitted to the command centre but not the restoration (OK message) of
this function.
20.1.11 Contact ID Reports
Select whether the restoration of a function (closing of an alarm zone, error clearance)
should be transmitted to the command centre. If only the basic function is enabled,
only faults or alarms are transmitted to the command centre but not the reset of this
function.
All transmitted messages are listed in the table. If “Basic + Restore” is selected, then
all messages plus their reset command are transmitted.
Trigger
CID Basic code with zone
no. and user
CID Basic + Restore
code with zone no. and
user
Medical control panel
100
100
Social care
101
101
Fire
110
110
Fire control panel
110
110
The following connection is recommended in Germany and Austria:
Under “Report Type”, select SIA 1
Under SIA Report, select Basic
The codes are now transmitted according to the table without zone
numbers and users.
Under SIA Report, select Sum
The codes are now transmitted again according to the table without zone
numbers and users.
Under SIA Report, select Middle
The codes are now transmitted again according to the table with zone
numbers and users added.