ABUS FU8007 Secvest 2WAY Base Kit Installation - Manual (Page 52)

52
13.11 Examples of zone properties
Part Set:
Detectors with the Part Set attribute secure your property from the outside.
You can move freely around the property.
This means:
The alarm centre only reacts to
detectors with the Part Set
property.
Force Set:
An interior door is secured with an opening detector. The detector is assigned the
Force Set property. The system can then also be activated when this door is open.
This detector is then no longer used for monitoring.
14. Outputs
The controller has 34 outputs.
The first two outputs (O/P1 and O/P2) are wired outputs.
Outputs 3 to 34 are wireless outputs. They can be accessed using a FU8210
accessory module or a wireless socket.
Switch outputs O/P1 and O/P2:
Disconnected, single pole relay contacts
DC: 24 V / 1 A
AC: 120 V / 0.5 A
14.1 Adding outputs
The Secvest has two wire outputs.
Select the Outputs menu item.
The Soak Test function should only be set when the detector has a
tendency of triggering false alarms. This function works automatically.
To test the detector range, use the walk test function. Do not activate
the detector test, as this function ensures that a message is stored in
the memory and no alarms are triggered when the wireless alarm
system is activated. The wireless alarm system sets the zone back to
normal after 14 days.
The Force Set function must be activated additionally in the System
Settings / Force Set menu.