ABUS FU8007 Secvest 2WAY Base Kit Installation - Manual (Page 55)

55
User Defined This zone can be remote-controlled by various components
such as remote control units or the code keypad. The output
can also be assigned times at which it is to be activated and
deactivated. If this output type is selected, the times at
which the output is to be activated or deactivated can be
entered at the end (see the note below).
FullSet RDY P1 - P4 This output is activated when the partition is ready to be
activated. A detector has been assigned to several
partitions. The relevant partition is ready, even if the
detector is still open.
Part Set P1 - P4 This output is activated if a partition is internally activated.
Full Set P1 - P4 This output is activated if the partition is activated.
Jamming Installer Menu Æ Outputs Æ Edit Outputs Æ Type Æ
Jamming
xThe corresponding output switches when jamming is
detected.
Perimeter Warning This output is enabled for approx. 30 seconds when a zone
with the attribute "Perimeter Warn" triggers an alarm.
System Fail This output is enabled for approx. four seconds when a
system failure occurs.
AC Fail This output is enabled as long as AC Fail appears in the
display. (Menu --> Facilities On/Off --> Mains Fail Rep Yes,
see A2-III users)
Reporting failure This output is enabled as long as a reporting failure is
present and the monitoring is switched to reporting failure.
Tampering This output is enabled as long as an element of the alarm
system reports tampering.
Burg This output is only enabled by a burglar alarm.
Any FULL SET This output is enabled as long as at least a partition is fully
enabled.
Select the function User Defined, for example.
End data entry by pressing Back.
14.6 Example: “User Defined” output type
After selecting the User Defined output type and entering the times, you can then
connect the programmed output with a wired input (programmed as “Key Sw
Latched”). In this way, the alarm centre can be activated and deactivated at a defined
time.
In addition, the “User Defined” output can also be remote-controlled. Program the
remote control unit in the user menu under “System -> Remote controls” (see user
manual).
14.7 Adding RF (wireless) outputs
The training procedure for the wireless output module is described here (function not
yet available).
Do not add outputs if the WAM (Wireless Accessory Module) is used as
an output module, as this reserves the outputs automatically. Consult
chapter 14.3 (Other devices / Adding WAMs).
Proceed as follows to add a wireless output (not necessary for outputs
on the accessory module):
In the installer menu:
Ж Ж
Select the Add Output menu item.