ABUS FU8007 Secvest 2WAY Base Kit Installation - Manual (Page 22)

22
3.8 Informing other persons
When the called party answers a call from the speech
dialler, they can end the call by sending back a DTMF
“5”.
When the “Call Acknowledge” function is activated, the
wireless centre ends the call to this number when it
has received a DTMF “5”. When the centre does not
receive a DTMF “5”, then it attempts to make a further
call (up to three times).
When the “Call Acknowledge” function is deactivated, the wireless centre ends
further call attempts to this number as soon as it determines that a call is
answered (i.e. when the receiver has answered). The called party can use DTMF
“5” to end the call.
Please note that the wireless centre now calls all other programmed numbers on
the voice dialler after receiving a DTMF “5”.
To prevent calls to other programmed numbers on the voice dialler, the called party
can confirm a call by sending back a DTMF “9”. The wireless centre stops all further
call attempts after receiving the “9” signal.
3.9 Signaller
To prevent manipulation of the siren, it should be attached
out of arm’s reach (at least 3 metres from the ground).
Please also take local legislations into account. In some
European countries, the use of external sirens is forbidden or
the maximum alarm duration is restricted. Contact your local
authorities for more information in case of doubt
.
Trigger the tamper contact of the siren.
In the speech dialler menu:
Æ
Select the Enabled menu item.
In the installer menu:
Æ
Select Ext Siren
.
In the EXT SIRENS menu:
Æ
Select Ext Siren 1 .