ABUS FU8007 Secvest 2WAY Base Kit Installation - Manual (Page 73)

73
17.7 PA response
Select whether an external alarm is also made in the case of a panic alarm (Full), or
whether only a telephone message is sent (Silent).
17.8 Auto rearm
Select how often the system should reactivate itself following expiry of the alarm time
(ext. siren duration).
The system activates all closed zones again, but not the detectors that still send alarm
signals.
When the system is reactivated, an acoustic internal alarm is emitted by the wireless
alarm centre instead of the normal entry tone when a user enters the property.
17.9 Siren Delay
Select whether the siren is to start immediately or after the selected delay time
following the triggering of a local or external alarm.
17.10 Siren Time
Select how long the siren should sound when a local or external alarm is triggered.
17.11 Stray on ent dly
Additional delay when the entry delay time is exceeded or the entrance to the property
differs.
Select whether an additional 30 seconds is allowed before an external alarm is
triggered after the delay time is exceeded or a different entrance path is used. If this
function is activated, only an internal alarm is triggered after expiry of the entry delay
time or when other zones are triggered. If this function is deactivated, an internal alarm
is triggered immediately after expiry of the entry delay time or when other zones are
triggered.
This option is used to fulfil the demands listed under guideline EN 50131-1.
17.12 Supervision
The alarm centre monitors whether the detector is present and active. W ireless
detectors send a message every 10 minutes and WAMs send a message every 4
minutes. When the status message is disabled, the alarm centre is in charge.
When the detector message is lost for more than two hours, then this is classified as
Fault, Tamper or Alarm:
There is no siren delay for a Fire Alarm, Panic Alarm or 24 Hour Alarm.