ABUS FU8007 Secvest 2WAY Base Kit Installation - Manual (Page 19)

19
3.6 Internal alarm active (Prt Set All)
This setting is used when the inside of the house should be accessed
freely whilst being protected against break-ins from the outside.
The detectors must be configured so that
external surveillance is
created.
Set the detector for external surveillance to “Part Set”.
The alarm centre then only reacts to detectors with the Part Set setting.
Call up the installer menu:
Select the Attributes menu item.
Change Part Set to Yes .
The Part Set setting is displayed with I.
When activation is made, you also have the possibility of Part Set All in addition to
Full Set All.
If more than one partition is assigned to the user, then this user can also select the
partitions.
The user can activate the partitions, activate them internally and deactivate them.
U = Deactivated
S
= Activated
P = Internally activated
U>P means that the partition status has been
changed from Deactivated to Internally
activated.
In the installer menu:
Ж Ж
Select the Edit Zones menu item.
The system shows the partition status at
the top-right of the display. A letter is only
shown in the partition (bar), when at least
one detector is present in this partition.