ABUS FU8007 Secvest 2WAY Base Kit Installation - Manual (Page 45)

45
This display shows which zone the detector has been trained to, the zone type
programmed for this zone, the partition that the detector monitors and the additional
zone attributes.
SS is also displayed, which shows the received signal strength. This value should be
higher than 3 for satisfactory communication.
If this message is displayed, consult the following chapter (9.4).
13.2 Deleting the detector or detector with zone information
Do you want to delete the detector or the detector with zone information?
After training, select the menu item by pressing Next .
In the case of an assigned zone of a WAM (WAM function 3 transmitter/receiver) "w2"
appears, for example.
Select the zone you wish to delete.
To delete the detector only, select the Delete Detector ID menu item and confirm with
Next .
Confirm deletion by pressing Yes .
To identify the detector at a later date, mark it with the zone number.
If a detector has been trained, then the symbol is shown next to the
zone number.
In the installer menu:
Ж Ж
Select the Add/Del Detectors menu item.