ABUS AZ4110 LCD Keypad for Terxon SX_MX Installation - Manual (Page 191)

87
UK
16.6 Test functions
090 Event memory
The alarm centre stores the last 250 events. Each event is
stored with date and time. The event memory can be
viewed via the program menu.
1. On the control unit, enter: 090
2. The LCD display shows the latest events first.
3. You can page forwards and backwards in the
event memory. Press key 1 to page forwards and
key 3 to page backwards.
4. Press to switch between the event and the
date.
5. Press to exit the event memory.
6. The event memory cannot be deleted by the
programmer or the user.
Entries in the event memory and their meaning:
Entry Meaning
MAINS Fail
Failure of 230V AC power supply
MAINS Fail
OK 230V AC power supply restored
Alarm Abort Alarm aborted manually by user
AUX DC Fail 12V DC power supply failed or AUX fuse
defect
AUX DC Fail
OK 12V DC power supply restored
Bad
Checksum Error in alarm centre memory
Batt Load Fail Failure of battery charger or battery fuse
defect
Batt Load Fail
OK Battery charger restored
Burg Zone nn Zone nn has triggered a burglar alarm
Burg Zone nn
OK
Zone nn OK
Defaults
Loaded Factory settings restored
EEPROM Fail Memory error in the alarm centre
Fire Zone nn
Zone nn has triggered a fire alarm
Fire Zone nn
OK Zone nn reset
Fire OK Fire alarm reset
Excess Keys A user has tried too often to enter code
in the control unit
Keyboard
Missing Control unit nn failed
Keyboard
Restore Control unit nn reconnected
Keyboard
Tamper Control unit has triggered a tamper
alarm
Keyboard
Restore Control unit nn tamper reset
Fire Zone
Alarm Fire alarm triggered at control unit nn
Medical Zone
Alarm Medical emergency alarm triggered at
control unit nn
Key Sw Set # Alarm centre activated via key switch of
zone nn
Entry Meaning
Key Sw
Unset #
Alarm centre deactivated via key switch
of zone nn
Key Box Cls
Z# Zone nn with key box property closed
Key Box Opn
Z# Zone nn with key box property opened
Lid Tamper The lid contact of the alarm centre was
triggered
Lid Tamper
Restore The lid contact of the alarm centre is
closed again
Batt missing Battery supply interrupted (cable not
plugged in)
Batt Flt
Restore Battery supply restored (cable
connected)
PA K -- Alarm BDT nn has triggered a panic alarm
PA Z -- Alarm Zone nn has triggered a panic alarm
PA Z -- Rstr
Panic alarm of zone nn reset
Set Fail Zone
-- The alarm centre could not be activated
since ZN nn was triggered
Fire Z –
Alarm Zone nn has triggered a fire alarm