ABUS AZ4110 LCD Keypad for Terxon SX_MX Installation - Manual (Page 126)

22
UK
11 Single system or
partitioned system
The alarm centre can be operated as a single system or
as a partitioned system. In the single system, all locations,
and 3 sections of the locations, are simultaneously
activated or deactivated. All control units, zones and
outputs work for the entire system.
If the alarm centre is functioning as a partitioned system
then it provides 4 smaller, independent alarm centres. In a
partitioned system:
every partition can be activated/deactivated
independently in case of an alarm.
various control units can be assigned to one or more
partitions. the control units can only activate/deactivate
partitions that are assigned to them.
every partition can have a separate signal transmitter.
zones can be assigned to several partitions, e.g. an
entry door zone can be used by several companies inside
a building.
A selection can be made between single systems or
partitioned systems the first time the alarm centre is put
into operation. If you want to change this later then use
command “98 Reset Factory Settings”.
For additional information, please read „Programming
Partitions“.