ABUS AZ4110 LCD Keypad for Terxon SX_MX Installation - Manual (Page 180)

76
UK
125 No signal „closed“
To change the settings:
1. On the control unit, enter: 125
2. The LCD display shows: 125:Omit > 1 OFF
3. Via the keypad, select from the following items
and press:
0 Omit >1 OFF
1
Omit >1 ON
The alarm centre does not transmit the
„closed“ signal if more than 1 zone is
locked.
(Function only with Scancom Fast
Format)
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double “beep” tone and shows Installer Mode.
126 Change language
To change the language used for the control unit display:
1. On the control unit, enter: 126
2. The LCD display shows: 126:Lang=English
3. Via the keypad, select from the following items
and press:
00 ENGLISH
01 ITALIAN
02 ESPANOL
03 PORT
04 NEDERL
05 FRANCAI
06 GERMAN
07 NORW.
08 SWED.
09 DANSK
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double “beep” tone and shows Installer Mode.
128 External alarm
All radio transmitters are monitored via the radio
expansion unit. If a radio zone has not communicated with
the radio expansion unit for more than 2 hours then this
reports a monitoring error. The external alarm function
describes how the alarm centre reacts to this fault. To
change the settings:
1. On the control unit, enter: 128
2. The LCD display shows: 128:Full Alarm
3. Via the keypad, select from the following items
and press:
0
Full Alarm
Sirens + call to central station
1
Local Alarm
Internal, external + control unit tone
2 Keypads only
3 Comms only
4
Inhibit Set
Control unit tone; the alarm centre can
not be activated until the faulty detector
reacts
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double “beep” tone and shows Installer Mode.