Printronix SL_T5R Energy Star - Manual (Page 97)

QUICK SETUP Submenus
97
Print Mode
This option specifies the type of printing to be done.
• Transfer (factory default). Indicates Thermal Transfer printing (ribbon
installed).
• Direct . Indicates Direct Thermal printing (no ribbon) and requires special
heat sensitive media.
Media Handling
This option specifies how the printer will handle the media (labels or tag
stock).
• Tear-Off Strip (factory default). Printer prints on the media and sends it
out the front until the print buffer is empty, then positions the trailing edge
of the last label over the tear bar for removal.
• Tear-Off . After each label is printed, the printer positions the label over
the tear bar and waits for you to tear off the label before printing the next
one (on-demand printing). A “Remove Label” message will display to
remind you to remove the label before the next one can be printed.
• Peel-Off . Prints and peels die-cut labels from the liner without assistance.
The printer waits for you to take away the label before printing the next
one (on-demand printing). When the optional internal rewinder is installed
with liner attached, a“Remove Label” message will display to remind you
to remove the label before the next one can be printed.
• Cut . When the optional media cutter is installed, it automatically cuts
media after each label is printed or after a specified number of labels
have been printed when a software cut command has been issued. It cuts
continuous roll paper, labels, or tag stock.
• Continuous . Printer prints on the media and sends it out the front. See
“Continuous Mode” on page 124 for more information.
Paper Feed Shift
This option represents the distance to advance (+ shift) or pull back (– shift)
the stop position of a label when Tear-Off Strip, Tear-Off, Peel-Off, or Cut
media handling option is enabled. The allowable range is -0.50 inches to the
current Label Length value setting, up to a maximum of 12.80 inches, in .01
inch increments.
The factory default is 0.00 inches.