Printronix SL_T5R Energy Star - Manual (Page 271)

271
C:
cd \download
13. Start the FTP (file transfer protocol) program by typing:
ftp xxx.xxx.xxx.xxx
where xxx.xxx.xxx.xxx is the IP Address of the printer.
14. Log in to the printer by typing:
root
You are given a password prompt.
NOTE: The default is no password. If the FTP program requires a password,
contact the system administrator.
15. At the password prompt, press .
16. Once logged in, type the following sequence at the command prompt to
download the filename .prg file to the printer:
cd dest
cd d1prn
bin
put filename.prg
where filename .prg is the file name you noted in step 9.
IMPORTANT Do not interrupt the downloading process once it has started.
Interrupting a download will leave the flash memory on the controller
PCBA and NIC incompletely loaded, and the printer may not boot up.
17. When the download is complete, exit the FTP program by typing:
quit
18. When the new software has successfully downloaded into flash memory
and the printer has reset itself, set the printer power switch to O (Off).
19. Remove the CD from the host computer and store it with the printer.
20. If required, reconnect the data input cable(s) to the printer.
21. Set the printer power switch to | (On).
22. Using the configuration printout(s) you made in step 1 on page 270,
restore the printer configurations.