Printronix SL_T5R Energy Star - Manual (Page 106)

106
Chapter 3 CONFIG. CONTROL
Name Config (1-8)
You may specify a 15-character name which can be used to refer to a
configuration. The name you enter for a configuration will be used in the Load
Config., Save Config., Print Config., Delete Config., and Power-Up Config.
menus. The names can only be cleared by using the Reset Cfg Names menu.
When you move into the Name Configs. menu, the top line of the display
shows the current configuration name. The second line of the display is
initially the same as the top line. You can modify the second line of the display
without affecting the top line until the
↵ key is pressed, which sets the
modified name as the current selection.
Press
↑ or ↓ to cycle through the values available for that character at the
cursor location. Press + to move to the next character to be modified. Press
−
to go back to a character you have already modified. Continue until you have
entered the name you want to give to this configuration, then press
↵ to save.
The name you entered will now represent this configuration on the printer's
front panel. To exit this menu without saving, press any key other than
↵. The
configuration name will revert to the last saved value.
The factory default is 1.
Reset Cfg Names
You can reset specific configuration names back to the default value of the
configuration number.
The options are 1 to 8 and All. The factory default is 1.
Auto Save
• Enable (factory default). When a change has been made to a Config.
menu, this option automatically prompts the user to save or not save the
change to a Config #.
If you are currently in the Factory Config. menus and make a change,
pressing Enter saves to Config 1 or the next available Config. and
becomes the Power-Up Config. If the Current Config is Config 1 and a
menu change is made, pressing Enter will save the change to Config 1.
• Disable . The printer will not prompt you to save any changes made.