Printronix SL_T5R Energy Star - Manual (Page 335)

Media
335
Figure 9. Media Dimensions
183422a
A
D
K G
D
A
C
E
G
A
B
D
C
I. Tag Specification
(Mark Sensing)
II. Tag Specification
(Gap Sensing)
III. Label Specification
(Gap Sensing)
Direction of Media Motion
Black Mark (on underside)
Direction of Media Motion Direction of Media Motion
Recommended
Cross Perf
Location
Recommended
Cross Perf
Location
Table 21. Media Specifications
T5X04R
SL5X04R
T5X06R
SL5X06R
T5X08R
A Label Width Range 1.00 -4.5 in.
19.1-114.3 mm 2.0-6.8 in.
50.8-172.7 mm 3.0-8.75 in.
76.2-222.3 mm
B Backing Width Range 0.75-4.5 in.
19.1-114.3 mm 2.0-6.8 in.
50.8-172.7 mm 3.0-8.75 in.
76.2-222.3 mm
C Min. Gap/Hole/Notch Height 0.10 in.
2.54 mm 0.10 in.
2.54 mm 0.10 in.
2.54 mm
K Min. Refl. Mark Height 0.10 in.
2.54 mm 0.10 in.
2.54 mm 0.10 in.
2.54 mm
I Min Refl. Mark Width 0.5 in.
12.7 mm 0.5 in.
12.7 mm 0.5 in.
12.7 mm
E Media Thickness Range .0025-.010 in.
.0635-.254 mm .0025-.010 in.
.0635-.254 mm .0025-.010 in.
.0635-.254 mm
G Width of Inter-label gap/hole 0.25-0.50 in.
6.35-12.7 mm 0.25-0.50 in.
6.35-12.7 mm 0.25-0.50 in.
6.35-12.7 mm
D Media Length Range
Continuous/Batch Mode 0.25 in. (6.35mm) - 99 in. (2515mm)
Tear-Off Strip Mode 0.25 in. (6.35mm) - 99 in. (2515mm)
Tear-Off Mode 1 in. minimum (25.4 mm) - 99 in. (2515 mm)
Peel-Off Mode
1 in. minimum (25.4 mm) - 99 in. (2515 mm)
(1)
Cut Mode 1 in. minimum (25.4 mm) - 99 in. (2515 mm)
These figures are approximate and depend upon the active emulation and application.
(1)
1.5 inch with validator support.