Printronix SL_T5R Energy Star - Manual (Page 39)

Loading Fanfold Media
39
15. Verify the printhead pressure is properly set. See “Printhead Pressure
Adjustment” on page 52.
16. Verify the pressure blocks are properly positioned. See “Printhead
Pressure Block Adjustments” on page 53.
17. Verify the Gap/Mark Sensor selection matches the type of media
installed. See “Sensing Different Media Types” on page 59.
For direct thermal operation (no ribbon required):
• If you have not run an Auto Calibrate, do so now. See “Running Auto
Calibrate” on page 60.
• If you have already run an Auto Calibrate, complete the following
steps:
a. Close the media cover.
b. Press the FEED key once to verify that the media advances.
c. Press the PAUSE key to place the printer online.
For thermal transfer operation (which uses a ribbon):
Complete the ribbon loading procedure (see “Loading Ribbon” on
page 40).