Printronix SL_T5R Energy Star - Manual (Page 200)

200
Chapter 3 EPSON FX SETUP
FF valid at TOF
The FF valid at TOF option determines whether the printer will perform a
Form Feed when the host sends a Form Feed command, if the printer is at the
top of form.
• Enable (factory default). Performs a form feed when the host sends a
Form Feed command and the printer is at the top of form.
• Disable . Will not perform a form feed when the host sends a Form Feed
command and the printer is at the top of form.
FF Validity
Determines if the position of a Form Feed (FF) command affects its execution.
• Off (factory default). Performs a form feed only if it occurs at the first print
position in a line or at Maximum Print Position +1. An FF command at any
other position is recognized as a blank.
• On . Allows the printer to perform an FF command anywhere in the data
stream.
Form Length (in.)
Form length is the number of lines that can be printed on a label. You can set
forms length in inches.
The factory default is shown in Table 3 on page 111.
Form Length (lines)
Form length is the number of lines that can be printed on a label. You can set
forms length as a function of the current LPI (lines per inch).
The factory default is shown in Table 3 on page 111.
Form Length (mm)
Form length is the number of lines that can be printed on a label. You can set
forms length in millimeters.
The factory default is shown in Table 3 on page 111.
Form Width (char.)
The forms width can be specified as a function of the current CPI (characters
per inch). The forms width set should not exceed the actual paper width.
The factory default is the maximum printing width divided by the selected
number of characters per inch.
Form Width (in.)
In this submenu, form width is specified in inches. The form width set should
not exceed the actual paper width.
The factory default is the maximum printing width.