Printronix SL_T5R Energy Star - Manual (Page 205)

Emulation Submenus
205
Host Form Length (VGL)
Sets the printer page size.
• Enable (factory default). Sets the printer label size equal to Label Length
from the host form length command. (For more information, refer to the
VGL Programmer’s Reference Manual .)
• Disable . Sets the printer label size equal to the Label Length set in the
front panel under the PRINTER CONTROL menu.
Host Override
Determines whether the printer accepts certain commands sent by the host,
or continues to use the current operator panel settings.
• Disable (factory default). Allows these host commands to override
operator panel settings: line length, forms length, lines per inch (LPI),
characters per inch (CPI), print quality, and text orientation. Note the
information appearing on the message display may not match the data
stream setting. No values will change upon initial selection of the Disable
option.
• Enable . The operator panel settings override the host commands.
Host PI
• Disable (factory default). The host does not send PI signals.
• Enable . The host sends PI signals. The Data Bit 8 configuration option
must be disabled to transmit the PI line to the printer.
I-2/5 Selection
This option is added to be compatible with a special
IGP-X00 customization. Usually, if Interleaved 2/5 bar codes have an odd
number of digits, a leading zero is inserted in front of the data. However, this
special IGP-X00 customization gives you the option of adding a space
character at the end of the bar code instead.
• Leading Zero (factory default). A leading zero is inserted in front of the
data.
• Trailing Space . A space is inserted at the end of the data instead of a
leading zero.
• X2 DPD . When selected, I-2/5 bar code with a magnification X2 will use
the specially configured ratios 3:3:6:5 rather than 3:6:9:12 for
compatibility issues.
• Modulo 7 CD . The I-2/5 bar code uses a modulo 7 check digit instead of
the default modulo 10 check digit.