Printronix SL_T5R Energy Star - Manual (Page 103)

QUICK SETUP Submenus
103
Validator Funct.
This menu appears only if a validator is installed.
• Enable . The printer will command the validator to begin scanning and
errors will be reported. The counters will be incremented while the
validator is enabled.
• Disable .The printer will not command the validator to begin scanning and
no errors will be reported. The counters will not be incremented while the
validator is disabled.
NOTE: If you save a configuration with the validator enabled, then power
down and power up, and the validator is not connected or not
functioning, the error message “Validator not communicating” will
display briefly. The Validator menu will not display.
If the validator is installed, the default is Enable.
Active IGP Emulation
See page 139 for more details.
xxx Diagnostics
See page 140 for more details.
Save Config.
This option allows you to save up to eight unique configurations to meet
different print job requirements. This eliminates the need to change the
parameter settings for each new job. The configurations are stored in memory
and will not be lost if you turn off the printer. If the Protect Configs. parameter
is enabled, the new configuration will not be saved unless the existing
configuration has been deleted first. The factory default configuration cannot
be changed. See “Saving a Configuration” on page 76 for details.
The factory default is 1.
Power-Up Config.
You can specify any one of nine configurations (1-8 saved custom
configurations or Factory) as the power-up configuration.
The factory default is Factory.
SMT:Status
You can enable or disable SMT functionality.
PAA: Select Tool
You can set the PAA:Select Tool to None (factory default), CST-1, or CST-2.
Refer to the
PrintNet Enterprise Suite User’s Manual .