Printronix SL_T5R Energy Star - Manual (Page 141)

PRINTER CONTROL Submenus
141
Power Saver Time
The time interval you specify for this parameter sets the amount of idle time
before the printer goes into Power Saver mode.
Pressing any key removes the power saver message from the control panel.
Sending a print job to the printer also turns off power saver mode.
The options are 1, 5, 10, 15, 30, 45, 60, and 240 minutes.
The factory default is 5 minutes.
NOTE: When ODV is installed and enabled, the printer will wait 20 seconds
before exiting Power Saver mode. During the Power Saver mode exit
a “PLEASE WAIT” message will display alerting user of the required
delay.
Pwr Save Control
Pwr Save Control allows you to enable and disable Power Saver mode. If
enabled, the menu for Power Saver Time is in effect.
The options are Enable (factory default) and Disable.
Display Language
This parameter chooses the language that will appear on the LCD: English,
German, French, Italian, Spanish, or Portuguese.
The factory default is English.
Alarm
• On (factory default). An audible alarm sounds (3 beeps) when a fault
occurs, such as a paper jam.
• Cont. Beep . A continuous audible alarm sounds when a fault occurs,
which can be stopped by pressing CLEAR.
• Off . No audible alarm sounds.
Power-up State
• Online (factory default). The printer powers up in the online state.
• Offline . The printer powers up in the offline state. This selection must be
saved as a power-up configuration to be used.
PTX Setup SFCC
Allows you to choose the hex value of the ASCII character you wish to use as
the SFCC for the PTX SETUP command. Valid hex values are 01-FF.
The factory default value is hex 21, which corresponds to the “!” character.