Printronix SL_T5R Energy Star - Manual (Page 108)

108
Chapter 3 MEDIA CONTROL
MEDIA CONTROL Submenus
Print Intensity
This option specifies the level of thermal energy from the printhead to be used
for the type of media and ribbon installed.
Large numbers imply more heat (thermal energy) to be applied for each dot.
This has a significant effect on print quality. The print intensity and speed
must match the media and ribbon type to obtain the best possible print quality
and barcode grades.
The range is from -15 to +15.
The factory default is -3.
TOF Detect
Fault
3 Labels*
9 Labels
1 Label
Ticket Save
Mode
Disable*
Enable
TOF Adjust
Mode
Disable*
Enable
TOF Adjust
0.00 to 0.40 inches
3
Peel-Off
Mode
1
Fast*
Standard
Continuous
Mode
2
Standard*
Tear-Off
Tear-Strip Full
Cut Strip
MEDIA
CONTROL
(from page 107)
Notes:
* = Factory Default
Italicized items are available only when Admin User is set to Enable (in the PRINTER CONTROL menu).
1 The Peel-Off option under Media Handling must be enabled for this menu to function.
2
The Continuous option under Media Handling must be enabled for this menu to function.
3 In increments of 0.01 inch.
4 Available when a 203 DPI printhead is installed.
5 Available when a 300 DPI printhead is installed.
Ribbon
Calibrate 1
Standard*
Forward Only
Vertical DPI
Adj
203*
4
195 to 210
300* 5
290 to 310
Reverse
Speed
2 ips*
1 to 6 ips