TANDBERG Media Processing System MPS 200 - Manual (Page 94)

D 13373.08
NOVEMBER 2007 MPS
Table of
Contents
TANDBERG MPS
ADMINISTRATOR GUIDE
PRI Board
Network Configuration E1/T1 Interface Configuration
E1 CRC4
Used for most E1-PRI configurations.
On: If set to On, the E1 CRC4 is enabled.
Off: If set to Off, the E1 CRC4 is disabled. If your network
equipment does not support this feature, turn it Off.
T1 Cable Length
Specifies the cable length between the TANDBERG MPS and
the CSU for each of the PRI lines (only valid for T1 networks).
Possible values are:
Range1: 0 to 133 feet •
Range2: 133 to 266 feet •
Range3: 266 to 399 feet •
Range4: 399 to 533 feet •
Range5: 533 to 655 feet •
This section configures each of the E1/T1 interfaces individu-
ally. There is one column for each interface (IF1, IF2,IF3, etc).
However, if PRI Trunk Groups is enabled, the number range
for PRI 1 will also apply for all the enabled PRI interfaces on
the same E1/T1 Interface Card.
Save - Press the Save button to save changes.
E1/T1 Interfaces
- continued: PRI Board Configuration
94
Introduction
Quick
Setup
Using
the MPS
System
Status
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices Main
System
Configuration