Security settings (2:2) – TANDBERG Media Processing System MPS 200 User Manual
Page 49
D 13373.08
NOVEMBER 2007
MPS
TANDBERG
MPS
ADMINISTRATOR GUIDE
MCU Overview > Create Conference
Encryption
On:
When set to On all participants in the conference must
support DES or AES encryption (available on all TANDBERG
endpoints using software version B4.0 or later).
Participants not supporting encryption will be shown the
‘Encryption Required’ screen for 60 seconds before they are
disconnected from the conference.
Off:
When set to Off the conference is not encrypted.
In an encrypted conference, there is no support for
telephone participants.
Encryption Mode
This settings only applies if
Encryption
is set to On (see
above).
Auto:
Set to Auto to use the highest level of encryption avail-
able on each of the participants connected in the conference.
This means that there can be a mix of DES and AES encrypted
connections in the same conference.
AES-128:
Set to AES-128 to allow only participants with AES
128 bit encryption capabilities. Participants without this capa-
bility will not be able to join the conference.
DES:
Set to DES to allow only participants with DES 56 bit
encryption capabilities. Participants without this capability will
not be able to join the conference.
!
Protect
On:
When Protect mode is set to On:
Only predefined Protected Numbers are allowed to join
1.
this conference.
The Protected Numbers field will be shown, and
2.
Protected Numbers can be configured from the Dial In
Configuration in the MCU Conference Overview page.
Off:
Set to Off to disable the Protect mode.
For further information on Protected Numbers, see
in the
Dial In Configuration
in the
Manage an Ongoing Conference section in this book.
Create Only
Select
Create Only
to create a confer-
ence, with the above-specified configura-
tion, without dialling out to any partici-
pants.
Add Participants
Select
Add Participants
to add participants
or to manually dial a participant.
Cancel
Select
Cancel
to discard all changes and
return to the
Conference Overview
page.
Security Settings (2:2)
49
Introduction
Quick
Setup
System
Status
System
Configuration
Installation
Gateway
Configuration
MCU
Configuration
Technical
Descriptions
Appendices
Main
Using
the MPS